Report
Question
We have low pressure with our well. We have replaced the pressure switch and no change? The well is down about 160' the pump is only 4 years old. Pressure tank is holding its pressure, Only thing left i guess ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
in progress 0
4 years 11 Answers 744 views

Report
Question
I'm building a lofted bed with a bookcase on one end, and I wanted to know if there was a way to slide the ladder above the bookcase when the bed isn't in use. I was thinking there were rails ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
in progress 0
Crys 4 years 9 Answers 814 views

Report
Question
I have a kitchen exhaust question that I hope you can help answer! We recently purchased a home and it has a ducted range hood (Broan Allure 250 CFM or so model) connected to a duct that goes through the kitchen ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
in progress 0
2 years 8 Answers 200 views

Report
Question
Putting a sub panel in a workshop. Only going to use lights and recepticals, no welding or high amp tools. I have run 20amp wiring through out the shop. I have a dedicated line just for lights which there will ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
  1. Please briefly explain why you feel this answer should be reported .

    Report Cancel
in progress 0
12 months 8 Answers 121 views

Report
Question
my oven i want to install requires 220Volt , and in my apartment electrican panel its two wires but phase to phase give 0 and separate 110 each . should i install 220 in that palen for my oven ?

Please briefly explain why you feel this question should be reported .

Report
Cancel
in progress 0
8 months 8 Answers 26 views

Report
Question
I have a new ge dryer rated at 20amp 120v. My outlet is a pre 1990s 3 prong dedicated 30amp 120/240 outlet to a double 30amp breaker. The cord that was given to me to fit the drier is rated ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
in progress 0
9 months 8 Answers 73 views

Report
Question
Hi Dominick, I am a DYIer with lots of experience/practice. Recently, due to budgetary constraints, I decided to learn how to "tune up" my heating system and hot water heater. There has been no problem with replacing the nozzles, cleaning the ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
in progress 0
Joe Mastrosanti 5 years 7 Answers 969 views

Report
Question
Thank you in advance for you help. I wish I could attach a photo. I have a house single story (big basement) house built about 1955. It has good bones. Seems very solid. Oak floors I have discovered but the living ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
in progress 0
4 years 6 Answers 560 views

Report
Question
Hi, I've been googling this one, and haven't been satisfied with the answers. Maybe you can give me a definitive one. I have a three-wire dryer outlet running to a 30 amp breaker (240v)...so: two hots, a neutral and the ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
  1. Please briefly explain why you feel this answer should be reported .

    Report Cancel
in progress 0
5 years 6 Answers 1730 views

Report
Question
Hey Dominick good morning, thank you for alot of them very helpful videos on youtube, some of them saved my neck lol, ok heres the question I have a natural gas heating system in my home.. water to base board, ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
  1. Please briefly explain why you feel this answer should be reported .

    Report Cancel
closed 0
5 years 6 Answers 800 views