Report
Question
I need to rewire my old Frigidaire electric range as some of the wire have become too brittle and rats have bitten some but is unsure what gauge of wire I should use. Don't know if the right grade should ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
in progress 0
3 months 0 Answer 18 views

Report
Question
Was working on a house today built in the '80s. The owner had me replace 3 ceiling fans and swap out a chandelier. In the front room, the ceiling fan was on 2 3 way switches...power was constant. Not sure ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
in progress 0
5 months 1 Answer 24 views

Report
Question
What wire and thickness is recommended for 150 ft @ 60-70amps (2 hot, 1 neutral, 1 ground) to the main 200a panel? Running across my attic, down wall, underground. Which type of wire? Copper SER? 4-4-4-6? Would that be best be ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
closed 0
6 months 2 Answers 42 views

Report
Question
I asked you about replacing a GFCI breaker w/o pigtail, and you said standard replacement would be fine. I went back and I guess I didnt notice last time, (there is a pigtail), is it still ok to change to ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
closed 0
6 months 1 Answer 22 views

Report
Question
Just wanted your thoughts when doing 15-20 amp lines for lighting connections. Wire nuts vs Wago? I have used both, I find the wago a better choice for lights at switch or junction connections. Wanted to know what you think ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
in progress 0
6 months 1 Answer 16 views

Report
Question
I have a client who wants me to help with an issue. They have a dedicated breaker to their washing machine. I have tested the breaker and it is holding the 120v on a 20amp GFCI breaker. It trips intermittently ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
in progress 0
6 months 1 Answer 8 views

Report
Question
my oven i want to install requires 220Volt , and in my apartment electrican panel its two wires but phase to phase give 0 and separate 110 each . should i install 220 in that palen for my oven ?

Please briefly explain why you feel this question should be reported .

Report
Cancel
in progress 0
6 months 8 Answers 26 views

Report
Question
I have a single pole 220 volt welder,here in canada single pole 220 volt is not available how i get around it to use the machine----can I use the double pole 220 volt--I mean from the welder one ...

Please briefly explain why you feel this question should be reported .

Report
Cancel
in progress 0
6 months 1 Answer 13 views